Cooling & Temperature Control


A  Single TCU equipped with the EcoTemp function results in numerous benefits right from start up. 


Single's EcoTemp technology is based on the variotherm principle in which the temperature of the cavity wall rises prior to the hot polymer melt being injected in the mould.  Cooling begins immediately after the cavity has been filled. 


EcoTemp units are easily interfaced with the moulding machine cycle, through which heating of the inserts takes place when the water flow is momentarily stopped. 


A significant saving in electrical power  consumption !


Other beneifts of using the EcoTemp technology:


  • Cycle time reduction in double digit % range
  • Same, if not better, part quality
  • Reduction in internal stresses
  • Less risk of warpage caused by shrinkage
  • Does not require any changes to the mould construction